Following recently released images showing a test print dry fit, Airscale has shared the first printed test build of their upcoming injection molded 1/32 Dornier 17 kit.
The clear parts are printed too and are very poor, the IM parts will be perfect. It was a valuable exercise as I found 30 design changes to improve fit and finish and it also helps to see it ‘in the flesh.’ When I get the moulded test shot parts in September, I will build a proper test shot – this one has a lot of geometric flaws from trying to print such large thin parts and the rivets and panel lines are half arsed, but it still looks the part.
Pre-orders are expected to launch in December limited to 100 kits. Click below to check out additional images.
(via Airscale)
